Current location:Home / News / Day health information / Introduction to Cold Heading Machine Learning
Introduction to cold heading machine.
1. Check that the knife plate, cutting knife bar, punch, die, etc. should be intact without cracks, installed correctly, and fastened firmly.
2. After adjusting the cutting mechanism, the clearance between the cutting mechanism and the die holder must be checked. It is strictly forbidden to start the equipment without checking.
3. When the cutter bar has been folded, the roller in the cam groove must be taken out before the equipment can be jogged.
4. When starting the equipment, the main motor can be started to drive the flywheel to rotate only when the feeding device is disconnected. Do not switch on the feeder until the flywheel is at full speed. When stopping the equipment, disconnect the feeding device first, and then stop the main motor.
5、不準將滑塊停在死點的位置上，如滑塊停在死點上時，只準用人工盤動飛輪的方法來糾正，不準開動設備。在切料刀桿已折的情況下，必須把凸輪槽中的滾輪取出后，方要點動設備。
6、經常注意盤料架的工作情況，發(fā)現混亂應立即停車。盤料加工到快完時，應將料尾從盤架上脫出。
Popular products
Recommended News
Features of Multi station Cold Heading Machine and Precautions in Use2022-10-31
After laser disk or bar tapping, the multi station cold heading machine automatically assembles various hexagon nuts, namely light standard hexagon nu…
Processing technology, mechanism and working principle of automatic cold heading machine2022-10-31
The automatic cold heading machine is a special equipment mainly used for the mass production of nuts, bolts and other fasteners. The earliest cold he…
How to debug multi station cold heading machine?2022-10-21
How to debug multi station cold heading machine? And precautions for operating the multi station cold heading machine. 1. Press and hold the emergency…
Analysis of Product Characteristics of High Speed Cold Heading Machine2022-09-30
Before using the high-speed cold heading machine, all problems should be eliminated. After a short time of idling, the operator can try to operate the…
Full system solutions for quality machinery manufacturersAll product pictures and publicity pictures of this website belong to us. No individual or organization is allowed to use them, and any embezzlement must be prosecuted.
Tel：0577-86266681Tel：0577-86125986mobile phone：13806699071E-mail：tianweimachine@126.comAdd: Haixi Industrial Park, Pingyang County, Wenzhou, Zhejiang
Service hotline
13806699071
We warmly welcome your consultation, and we will provide you with satisfactory mechanical solutions
